EGW Tanfoglio Vortex Razor/C-More RTS2/STS2 Sight Mount (Dovetail)

Mounting Hardware is Included

This mount fits:

• CZ 75 SP01 Shadow
• CZ Shadow 2
• Dan Wesson DWX
• Dan Wesson DWX Compact

THIS MOUNT DOES NOT FIT Shadow 2 OR (Optics Ready)

Red Dot Fitment: Vortex Viper/Venom, Burris FastFire, Crimson Trace CTS-1200, CTS-1300, Docter, ADE RD3-001*, ADE RD3-02*, ADE RD3-009*, UTG Reflex Micro Dot, Sightmark Mini Shot Red Dots, Sightmark Core Shot Red Dots

The EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Specifications:

Material: 7075 Aluminum

• Coating: Matte Black Hardcoat

  Overall Length: 1.811″

  Overall Width: .99″

  Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw

*All ADE mounts require 6-32 x 3/8″ screws not included

Please note: Some red dots commonly found on Amazon such as the UTG and ADE may not hold the same tolerances as the red dots that this mount was initially created to work with. These dots may not fit properly on the posts on the plate. We would recommend either sending the red dot back for an exchange to whichever seller you purchased it from, or open up the holes in the bottom of the red dot to accommodate the pins.

The EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions:

– Remove the rear sight*

– Install the EGW Sight Mount in the dovetail

– Tighten set screw (if applicable)

– Place the red dot sight on the EGW Sight Mount

(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)

– Apply blue Loctite to the provided mounting screws

– Torque mounting screws to 15in/lbs

2 Button Head Cap Screws – Provided for Vortex Viper and Venom Sights

2 Flat Head Cap Screws – Provided for Burris FastFire and Docter Sights

The screws that are included with this mount require a 5/64” allen wrench for installation.

• Modification of your firearm may nullify the manufacturer’s warranty.
• This product should be installed and checked by a qualified gunsmith.
• No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.